MAP1150 Storage facility image control switches

The storage facility image code control switches set determines the code behavior.

Procedure

Display or set the storage facility image control switches.
  1. From the navigation area, click Storage Facility Management > storage facility > SF image.
  2. From the task area, select Service Utilities > Enable/Disable Control Switches.....
    • The figures shown are examples of the control switches. Your level of code may have different switches displayed.
    • To determine the behavior of each switch setting, see the IBM DS8000 Introduction and Planning Guide for your model.
    • The control switch settings should be part of the customer configuration worksheet that the customer provides for use during the installation.
    Figure 1. Window: Control switches (view or set)
    Note: This view is the left side of the display, which contains switches that can be set.
    Window: Control switches (view or set)
    Figure 2. Window: Control switches (view only)
    Note: This view is the right side of the display, which contains switches that can be viewed but not set.
    Window: Control switches (view only)