Completing the storage facility safety inspection

Use this section to complete the safety inspection.

Before you begin

CAUTION:
Do not attempt to switch on power to the machine until all unsafe conditions are corrected. (1050)
CAUTION:
Assume that an electrical safety hazard is present. Perform all continuity, grounding, and power checks that are specified during the subsystem installation procedures to ensure that the machine meets safety requirements. (1051)
Note: This notice is translated into selected languages. See IBM® Systems Safety NoticesG229-9054-xx.

Procedure

Perform one of the following steps to complete the inspection:
  • Installation: return to Installing.
  • Relocate or discontinue:
    1. Perform all the electrical safety checks. See Performing the power and safety checks.
    2. Reinstall the two screws  1  on the rear left machine cover. See Figure 1.
      Note: The screws must be installed to prevent non-service personnel from accessing a hazardous section of the machine.
      Figure 1. Removing retaining screws on right rear machine cover
      enter alt text here