Exchange the CEC enclosure disk drive

Before you begin

Icon for electrostatic discharge wrist strapUse approved ESD procedures to prevent damage.

Attention:
  • This procedure is not a stand-alone procedure. Customer disruption and damage to the hardware might occur when microcode and power boundaries are not in the proper conditions for this service action.
  • If a serviceable event FRU repair directed you to this procedure, the microcode and power boundaries are already set.
  • If a serviceable event FRU repair did not direct you to this procedure, see MAP1230 Replace a FRU without using a serviceable event.
Notes:
  • All the cables and FRUs to be removed must be uniquely identified so they can be reinstalled correctly.
  • If an installed earthquake resistance kit prevents you from accessing this FRU, refer to MAP1600.

Remove the CEC disk drive

About this task

Note: The CEC disk drive FRU must be replaced with a different FRU. The FRU verification checks the disk drive serial number and will fail if the original FRU is reinstalled.

Procedure

  1. To locate this FRU, take one of the following actions and then return here and continue to replace the FRU:
    • If this FRU has a FRU identify indicator, use the FRU identify indicator, which is listed in MAP1240 Locating FRUs by using identify indicators. If not, use the location code.
      Note: There might be cases where the FRU failure or fencing conditions prevent the FRU LED indicator from being lit even if the FRU has power.
    • Use the location code, which is listed in MAP1245 Finding FRUs by using location codes.
    • If there is no FRU identify indicator or location code, you were sent here by an isolation MAP or symbolic FRU procedure. Use the information in that procedure and the figures in this procedure to locate the proper part to exchange.
  2. Most, but not all, FRUs have identify indicators. Use the flashing amber or solid blue FRU identify indicators to ensure that you are working on the correct enclosure or FRU.
  3. Squeeze the bottom of the CEC disk drive handle Callout label A to unlock it. See Figure 1.
  4. Pull the CEC disk drive handle Callout label B out and then up. See Figure 1.
  5. Grasp the CEC disk drive Callout label C, supporting the bottom, and slide it out of the disk enclosure. See Figure 1.
    Figure 1. Removing the CEC disk drive
    Removing the CEC disk drive

Install the CEC disk drive

Procedure

  1. With the CEC disk drive handle in the up position, carefully slide the CEC disk drive Callout label A into the enclosure until it stops.
    Note: The CEC disk drive FRU must be replaced with a different FRU. The FRU verification checks the disk drive serial number and will fail if the original FRU is reinstalled.
  2. Move the CEC disk drive handle Callout label B down into the locked position to seat the CEC disk drive fully in. Verify that the front of the new CEC disk drive is aligned with the other CEC disk drives. See Figure 2.
    Figure 2. Installing the CEC disk drive

    Installing the CEC disk drive

  3. Exit this service information center parts exchange procedure and return to the procedure that sent you here.